User manual
14
en
• Should the powercord be damaged during use, im-
mediately disconnect it from the mains. Do not
touch the cable until it has been disconnected from
the mains.
• Never leave the trimmer without supervision. Store
it in a safe place.
• The switches installed shall not be removed or
bridged over, e. g. by binding the switch to the han-
dle.
• Do not allow the cord spool to strike the ground or
edges of working area. If the cord spool receives a
hard knock, this will cause a strong vibration on the
handle. If this occurs, the trimmer should be
checked by a qualified service centre.
After operating
• After using the unit, disconnected the power cord
from the wall outlet and inspect the unit for damage.
• When switching off the trimmer: Attention: the cut-
ting tool does not stop immediately!
• Always wait for the cutting tool is stop.
•
Before servicing or cleaning the unit, removing
the guards or replacing the line cassette, switch
off the motor and cutter and pull out the mains
plug.
Only use original WOLF-Garten cord spools
and note the installation instructions!
• The cutting knife should not be cleaned under run-
ning water or under high-pressure.
• Faults shall only be repaired by appointed service
centres or by the manufacturer.
• Make sure all air holes are free of dirt.
• Do not store the unit within reach of children.
Disposal
Operation
Operating times
• Please check noise abatement regulations prevail-
ing in your country.
Working angle
GTE 840 - GTE 845 - Blue Power GTE 850
A
The trimmer has 4-adjustable working angles. This
allows you to easily reach hard to reach areas in your
garden
C
.
1. Press the lock button .
2. Adjust to the desired working angle .
The handle noticeably snaps into place.
Free-cutting
1. Hold the device at the upper and middle grips.
2. Swing the device in semicircles in front of the body
(without touching the ground).
3
Notes
• The optimal working angle for cutting is 30°.
• Cut high grass slowly, step by step.
Edge trimming
The edge trimming function allows you to trim your
grass precisely all around the edge of your lawn
E
.
GTE 840 - GTE 845 - Blue Power GTE 850
A
1. Press the lock button .
2. Rotate the cutting head by 90° (the cutting
head will audibly click into place).
3. Press the lock button .
4. Adjust the working angle (the handle will audi-
ble click into place).
GTE 830
B
1. Press the locking button .
2. Turn the cutting head by 180° until it clicks into
place .
Wheels
GTE 845 - Blue Power GTE 850
Use the wheels provided to achieve a clean cut at a
uniform height
F
. Wheels are particularly useful
when edging.
•
Assembly or height adjustment according to dia-
grams
.
Do not dispose of electrical equipment
in
domestic waste. Recycle equip-
ment, accessories and packaging in an
environment-friendly manner.
D
G
H
J