User manual
15
en
Adjusting the length of the bar
GTE 840 - GTE 845 - Blue Power GTE 850
1. Loosen the threaded sleeve .
2. Pull the telescopic handle out until the shaft is the
length you require .
3. Tighten up threaded sleeve .
Adjusting the mid-grip
1. Loosen the clamp on the loop handle .
2. Push the loop handle to the height you require .
3. Tighten up the clamp .
Motor guard/guide rail and plant protector
Blue Power GTE 850
M
The motor guard protects the motor from damage
caused by impacts or blows. At the same time the
guard acts as a guide rail to facilitate operation.
The plant protector protects shrubs, trees and bed-
ding plants.
• Pull the plant guard out of the cutting head and reat-
tach it as shown .
1
The plant protector must remain inserted at
the rear for edging tasks .
Threading the cable through the strain
relief mechanism
The cable strain relief mechanism in the guide handle
prevents the extension lead from becoming discon-
nected accidentally.
• Please fasten the extension lead as shown into the
cable strain reliever.
Connect to the socket (230 Volt, 50 Hz)
• Connect the device only to sockets that are protect-
ed with a 10-16 Amp. fuse (or LS switch type B)
3
Note: Residual current protection device
These safeguards provide protection against
severe injuries resulting from touching dam-
aged cables, insulation defects and in some
cases cables that conduct electricity.
• We recommend that the equipment only be plugged
into a power socket, which is protected by a residual
current protection device (RCD) with a residual cur-
rent of no more than 30 mA.
• Retrofit kits are available for old installations. Con-
sult an electrician
Switching on and off
1
Caution! Spinning strands
Tool continues spinning after switching off!
Switching on the device
• Press and hold down the on/off switch .
Switching off the device
• Release the on/off switch.
Blue Power Button
Blue Power GTE 850
The Blue Power Button allows you to work in an en-
ergy-saving, environmentally friendly and with lower
n
oise levels at a reduced rotary speed.
• Press the Blue Power Buttons while the motor is
running in order to reduce its rotary speed .
• Press the Blue Power Buttons again while the motor
is running in order to bring its rotary speed back up
again .
Thread adjustment
GTE 840 - GTE 845 - Blue Power GTE 850
• If the cutting cord becomes too short due to normal
wear, simply switch off the trimmer. The cord will
then automati-cally adjust to the correct length.
• Whenever the trimmer is switched off and then on
again, the cord automatically lengthens 6-8 mm. If
the trimmer is fre-quently switched on and off for no
reason, this will increase wear of the cord.
GTE 830
P
• Briefly tilt the running machine on a firm base, e. g.
paving slab (approx. 3 kg pressure). Approx. 2,5 cm
cutting thread are the automatically paid out.
K
L
N
O
O