User manual

16
en
Maintenance
Cleaning
1 Attention! Rotating string!
Tool is still running!
• Always disconnect from the power supply
before performing any work on the trimmer!
• You can prolong the life of your trimmer by remov-
ing grass from the ventilation slots and the bottom
of the trimmer before or after each use.
Replacing the cord spool
1 Attention! Rotating string!
Tool is still running!
• Always disconnect from the power supply
before performing any work on the trimmer!
1 Before switching on: Hold trimmer parallel
to the ground; otherwise, there is danger of
injury.
GTE 840 - GTE 845 - Blue Power GTE 850
Q
1. Press both locking tabs of spool cover simultane-
ously and remove + .
2. Remove cord spool.
3. Clean, if necessary.
4. Insert cord spool into housing .
5. Thread the end of the wire through the eye of the
wire box .
3 To avoid inadvertent unwinding, do not
take wire on the new spool out through the
support holes before inserting .
6. Place the spool cover on the cord spool holder so
that the two locking tabs lock into place.
GTE 830
R
1. Forcefully press both catches together on the
spool cover and remove .
2. Remove line spool.
3. Remove any soiling.
4. Feed the end of the line from the new line spool
through the line eyelet in the housing cover and in-
sert the spool cassette into the housing cover .
3 Ensure that the line spool is inserted as il-
lustrated.
5. Attach spool cover to the line spool holder, ensur-
ing that both catches click into position .
1 When the lawn trimmer is switched on, the
line is cut to working length. Switch on unit
in operating position only.