Installation Guide

bossjambs.com
Patented
Jamb
Reinforcements
A
C B
D
G
F
E
E
E
E
E
D
D
BOSSJAMB™ PARTS LIST BREAKDOWN
(1 piece) 36-1/4” Top Jamb. Labeled A
(1 piece) 82-3/4” Lock Side Jamb. Labeled B
(1 piece) 82-3/4” Hinge Side Jamb. Labeled C
(3 piece) Weather Stripping. Labeled D
(5 piece) #14 X 4” Wood Screws. Labeled E
(1 piece) Deadbolt Strike Plate. Labeled F
(1 piece) Driver Bit for Wood Screws. Labeled G
Bossjamb™ Break-in resisatant exterior door Frames
by Crescent Door Works LLC
New Orleans, LA
www.bossjambs.com
Bossjambframes are for use only in rough openings framed for
a single door, and are not recommended for use with sidelights.
Begin by determining the swing of your exterior door and frame.
Refer to the illustrations below to determine whether left hand
inswing or right hand inswing Bossjamb™ door frame models are
correct for your project.
BOSSJAMB™ OVERVIEW AND ASSEMBLY
left hand inswing
viewed from exterior
right hand inswing
viewed from exterior
Bossjamb™ model 43068LH Bossjamb™ model 43068RH
TOOLS REQUIRED FOR INSTALLATION:
OTHER TOOLS NEEDED TO COMPLETE THE PROJECT:
• Safety Glasses
• Drill, 3/16” Drill Bit
• Tape Measure
• Miter Saw (needed only if jambs require trimming to fit non-standard door)
• Level
• Framing Square
• Caulk Gun
• #9 X 3” Wood Screws
• Wood Shims
• Caulk
• 3 Piece Brickmould Kit, Exterior Trim
• 3 Piece Interior Wood Trim Kit
• #9 X 2” Wood Screws
• Top Coat with 2 Coats Exterior Oil-Based or Latex Paint
Measure from the top of the door to:
Top of
First
Hinge
6-1/2”
Top of
Second
Hinge
37-1/2”
Top of
Third
Hinge
68-1/2”
Center-
line of
First
Bore
40-3/8
Center-
line of
Second
Bore
45-7/8”
Bossjamb™ Exterior Door Frame kits are
factory routered for standard residential 4
hinges and lock strike hardware. They are
ideal for blank exterior door slabs (doors
that have not been routered for hinges and
drilled for locks) up to 36” wide, 80” high,
and 1-3/4” thick.
Refer to the hardware location illustration
below to determine where to lay out hinges
and lock bores on a blank door slab to match
the hinge and lock prep on a Bossjamb
Exterior Door Frame.
MATCHING A DOOR TO BOSSJAMB™ HINGE AND LOCK PREP

Summary of content (2 pages)