Use and Care Manual

ELECTRICAL SAFETY INSTRUCTIONS
WARNING! ELECTRICAL SHOCK. Read and understand all instructions. Failure to follow all
instructions listed below, may result in electrical shock, fire and/or serious personal injury.
SAVE THESE INSTRUCTIONS.
Grounding Instructions
This fountain must be plugged into a 3-wire, 3-prong outlet that is properly working and has
been installed and grounded in accordance with all local, state or federal codes and ordinances.
DANGER: IMPROPER INSTALLATION OF THE GROUNDING PLUG CAN RESULT IN A RISK OF
ELECTRICAL SHOCK. Check with a qualified electrician or serviceman if the grounding instructions
are not completely understood, or if doubt as to weather the product is properly grounded. Do not
modify the plug provided; if it will not fit the outlet, have a proper outlet installed by a qualified
electrician. Do not use any type of adapter with this product.
Attach Hand Pump Assembly
1. (SEE FIGURE 1) Face water faucet on hand
pump (C) towards tub opening and attach hand
pump to top of tub (A). Secure using
screws (E).
NOTE: Do not plug in pump before filling
tub with water. Running the pump without
water may damage pump.
Mount Small Wash Tub
1. (SEE FIGURE 2) Position small tub (A) over
large tub (B). Align mounting studs with
previously drilled holes at top of tub (B).
2. Install mounting studs through holes.
Secure tub (A) to tub (B) using bolts (F).
Install Hand Pump Assembly
1. (SEE FIGURE 3) Place Hand Pump with Pipe
(C) through top washtub (A) and then down
through bottom washtub (B).
2. Align Hand Pump with Pipe (C) over extension
3.
tube at top of pump (D). Push down on Hand
Pump with Pipe (C
) until fully seated.
Plug power cord into properly grounded
120V AC outlet.
4. (SEE FIGURE 4) Ready for use it.
Adjust Speed of Water Flow
1. Unplug pump (D) from AC power outlet.
2. Move adjustment switch on pump (D)
toward "+" positive to increase water
flow, or "-" to decrease water flow.
Maintenance
1. Check water level periodically, add
water if necessary.
2. If water is not flowing, check pump (D),
hand pump with Pipe (C) inside for clogs.
NOTE: Pump may build up calcium after a
long period of time and stop running when
tap water is used. Any calcium remover can
be used to clean pump.
PARTS & HARDWARE LIST
PART # DESCRIPTION QUANTITY
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
CAUTION: Do not over tighten fasteners.
ASSEMBLY INSTRUCTIONS
B
C
D
E
F
A
Figure 2
Figure1
A
A
B
B
C
E
E
1
2
A Small Washtub 1
B Large Washtub 1
C Hand Pump with Pipe 1
D Pump 1
E Screw 3.5x20mm 3
F Bolt 6x40mm 2
Figure 3
Figure 4
D
C
A
F
F