Decorative Metal Installation Instructions

page 5
• Gate posts should be set at:
A. 2-in (inside of post to inside of post) wider than the actual gate width if using self-closing hinges.
B. 3-1/2-in (inside of post to inside of post) wider than the actual gate width if using Complete Gate
Hardware Kit.
• Attach hinges to the gate first and then the post.
Note: If using Complete Gate Hardware Kit, 1/2-in holes must be drilled in the gate frame to accept
the J-bolt gate frame hinges.
• Mount Striker across the top rail of the gate and the Receiver Latch with corresponding placement on
the latch post.
• Mount & tension Gate Spring:
A. For Complete Gate Hardware Kit: mount the Gate Spring between the hinges on the gate and post
with the high side of the Gate Spring on the gate. Set tension to the desired level.
B. For self-closing hinges: simply use an allen wrench to set the tension at the desired level.
Hang Gate
3
COMPLETE GATE HARDWARE KIT
Receiver Latch
Striker
Self-Closing Gate Hinge
Gate Frame Hinge
Gate Post Hinge
Gate Spring
Receiver Latch
Striker
SELF-CLOSING GATE KIT