Instructions / Assembly
11
INSTALLING THE HOPPER, IGNITER & PROBE WIRE
Ste
p 3 Attaching the hopper to the barrel:
• The mounting bracket on the rear of the hopper (B) must be raised
slightly higher then the receiving bracket on the barrel. (A)
Diagram A & B
• Begin by slightly inserting the igniter into the installed Burned Pot
at the bottom side of the barrel.
Next slightly insert the Auger Feed tube into the correct hole.
. It might be necessary to raise the hopper slightly to ensure the
mounting bracket on the hopper will go over the receiving
bracket on the barrel.
• Push Hopper tightly against the main barrel.
Next holding the hopper fairly level, press downward to clip the
hopper onto the mounting bracket. Diagram C & A
• Using your 5/16” nut driver or standard screwdriver and the
4 1/4x20-1/2” hex screws, secure hopper to barrel through
the holes provided, inside the barrel. Diagram D
NOTE: If the holes do not line up,
the hopper may need to
be fully clipped into place.
B
C
D
A
As
sembly Instruction