Instructions / Assembly

ASSEMBLING YOUR BIKE

FRONT WHEEL

1. Remove the nuts, washers and wheel retainers from the front wheel.

2. Slide the wheel onto the open ends of the fork. Slip an axle retainer onto each end

of the axle, and hook the retainers into the holes in the fork end. Loosely install the

washer onto each end of the axle (serrated end toward the retainer), then install the

hex nut. (Note: there may be a washer head nut in place of the washer and hex nut).

3. Center the wheel in the fork and tighten the axle nuts securely, alternating from one

side to the other.

4. Spin the wheel to make sure that it is centered in the fork and does not wobble. If

the wheel is not centered, loosen the nuts and try again.

Torque requirement: 16-20 ft.. lbs.