Instructions / Assembly

KICKSTAND
If your bike is equipped with a kickstand, please follow the instructions below.
1. Place the bicycle in an upright position.
2. Remove the top plate from the kickstand.
3.
From the left side of the bicycle (opposite side from chainring), place the kickstand
in position beneath the two rear fork legs.
5. Replace the washer and nut onto the mounting bolt. Hold the kickstand arm in an
up position aligned with the frame stay, then securely tighten the mounting bolt.
6. Leave the leg of the kickstand down so it will support the bicycle during the rest of
the assembly process.
WARNING! THE KICKSTAND IS DESIGNED TO SUPPORT THE
BICYCLE ONLY, NOT THE BICYCLE AND RIDER.
REAR MOUNT KICKSTAND
If your bike is equipped with a rear mount kickstand, please follow the instructions below:
1. Lean the bike against a wall for support, so that the right side (chainring side) is
facing the wall and the left side of the bike is facing out.
2. Remove the rear axle nut and washer from the left side rear wheel.
3. Slide the kickstand plate onto the axle, so that it is seated against the rear dropout.
4. Slide the washer and nut back onto the axle and tighten securely.
5. Leave the leg of the kickstand down so it will support the bicycle during the rest of
the assembly process.
WARNING! THE KICKSTAND IS DESIGNED TO SUPPORT THE
BICYCLE ONLY, NOT THE BICYCLE AND RIDER.
WARNING! Use your kickstand to support
the bike when not riding. Allowing your bike to
lay on it’s side can damage the brake levers and
cause an unsafe riding condition and
could result in injury to the rider.
16