Instructions / Assembly

PEDAL INSTALLATION

1. Apply a small amount of grease to the threads of each pedal. Look for

the letter “L” or “R” on the side or end of each pedal spindle (picture).

Turning the spindle clockwise by hand (Picture), thread the pedal marked

“R” into the crank arm on the right (drive) side of the bicycle. Make sure

that you are not “cross-threading”, which can strip the threads in the

crank arm. If the threads do not turn easily, don’t force them. Back the

spindle out and start over. Once the pedal is threaded into the crank arm,

tighten the spindle securely to the crank arm with a 15mm open end or an

adjustable wrench.

2. Turning the spindle counterclockwise by hand, thread the pedal marked

“L” into the crank arm on the left side of the bike. Make sure that you are

not “cross-threading”, which can strip the threads in the crank arm. If the

threads do not turn easily, don’t force them. Back the spindle out and start

over. Once the pedal is threaded into the crank arm, tighten the spindle

securely to the crank arm with a 15mm open end or an adjustable wrench.

WARNING! IMPROPERLY INSTALLED AND TIGHTENED

PEDALS CAN WORK LOOSE, DAMAGING THE BICYCLE

AND CAUSING POSSIBLE SERIOUS INJURY OR DEATH

TO THE RIDER

Torque Requirement 15-18 ft.. lbs.