Instructions / Assembly

HANDLEBAR AND STEM INSTALLATION

STANDARD ONE PIECE STEM ASSEMBLY

1. Remove plastic material covering the expander wedge. Loosen the stem expander bolt,

if necessary, so the wedge nut is in line with the stem body. See illustration.

2. Insert the stem into the head tube past the minimum insertion line indicated on the

stem.

WARNING: THE HANDLEBAR STEM MUST BE INSERTED INTO THE

HEAD TUBE UNTIL THE MINIMUM INSERTION LINE INDICATED ON

THE STEM IS COMPLETELY COVERED.

3. Face the handlebar stem forward directly in line with the front wheel. Make sure the

fork is in the correct position (facing forward) before tightening the expander bolt.

See illustration on this page.

4. Tighten the expander bolt securely (turning in a clockwise direction). Recommended

torque is 20 ft. lbs.

WARNING: THE ASSEMBLER IS CAUTIONED AGAINST THE DANGER

OF DAMAGING THE HANDLEBAR STEM ASSEMBLY AND POSSIBLE

INJURY TO THE RIDER IN OVERTIGHTENING THE EXPANDER BOLT

AND EXPANDER WEDGE.

HANDLEBAR INSTALLATION

1. Loosen the stem clamp bolt.

2. Insert the handlebar into the stem.

3. Tighten the stem clamp bolt securely.

4. Check the handlebar for tightness. If you can move it forward or backward, the clamp

bolt is not tight enough.

5. Check steering by straddling the front wheel and trying to turn the handlebar. If you

can turn the handlebar without turning the front wheel. The stem is too loose. Align

the handlebar with the front wheel. Retighten the expander bolt (clockwise).

Recommended torque is 15 ft. lbs