Instructions / Assembly

1. Locate the seat, seat post and clamp hardware.
2. Place the lower seat clamp plate onto the head
of he clamp so the grooves on the plate match
the grooves on the head.
3. Place the rails of the seat into the channels of
the lower seat clamp plate, with the nose of
the seat on the opposite side of the clamp set
back.
4. Place the upper plate with the channels of
the seat clamp aligned with the seat rails.
5. Place the concave nut into the groove on the
top of the upper plate.
6. Insert the allen bolt through the hole on the
underside of the seat clamp head and thread it
onto the concave nut with a 6mm allen wrench.
7. Insert the seat post (with seat attached) into the
bike frame.
BE SURE THAT THE SEAT POST IS
INSERTED PAST THE MINIMUM
INSERTION LINE.
8. Tighten the seat post binder bolts securely at
the desired height.
9. Adjust the angle of the seat so that the top of
the seat is parallel to the ground or comfortable
to the rider.
10. Retighten the allen bolt securely. Check for
tightness by attempting to pivot the seat up
and down. If the seat is loose, be sure to tighten
the clamp (allen) bolt securely.
Torque required 20 to 25 Nm - 250 in lbs.
SEAT POST
SEAT CLAMP
SEAT POST BINDER BOLTS
BIKE SEAT TUBE
SEAT POST
HEAD
LOWER SEAT
CLAMP PLATE
UPPER SEAT
CLAMP PLATE
SEAT RAILS
CONCAVE NUT
ALLEN BOLT
SEAT
If your bicycle is equipped with a clamp type seat post, please follow instructions.
SEAT & SEATPOST ASSEMBLY
22