Welcome to INSTALLATION AND QUICK START GUIDE Bluetooth® Connected Thermometer
A Parts List: AA AA AA AA AA AA Red AA For Liquid Propane Gas Grill Models Only Yellow Tools Required: AA AA AA AA AA m AA AA AA 3- AA AA AA Follow the steps that apply to your specific grill model: - or - AA
1a Save OR recycle parts: Remove “iGrill 3 ready” plate.
1b Remove LED Fuel Gauge.
2 Ensure tank scale has one magnet installed.
3 Save OR recycle parts: Install bracket underneath side table.
4 AA - Do not mix old and new batteries. Do not mix alkaline, standard or rechargeable batteries.
5 Battery Cable Connection
6 Lighted Control Knob Connection Pre-installed on Genesis® II LX only.
7 LP Fuel Level Sensor Connection
8 Snaps into place. No screws required.
Clean surface before applying wire clip. 9 Peel and stick. m Must secure all wires using the wire retention clip.
10 Quick Start Guide a Download the Weber iGrill App b Press and release the power button c Launch app and connect through Bluetooth® A full user guide is available inside the Weber iGrill App and online at support.weber.
Display Bluetooth® LED Blinks blue when discoverable and awaiting pairing
Probe Insert Four probe inserts to monitor four temperatures at once
Colored Probe Indicator Easily identify each probe reading within the app
Probe Wrap Neatly wrap and store your probes on the back of your unit when it’s not in use
WARNING Colored probe indicators not intended to be used as heat safety grips. Probes are NOT dishwasher safe. Supported Devices: App requires a Bluetooth® Smart Ready device. Check support.weber.com/igrill-support for a list of compatible devices. Operation Is Subject To The Following Two Conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of this device.
