Installation Guide

12
12.
13.
14.
Assemble your stair railing section:
a. Lock tabs on baluster/spindle must face outer
edge of routed holes in rails (Fig. 16).
b. Assemble your stair section by snapping
balusters/spindles in rails.
c. Place brackets on ends.
d. Place assembled stair rail between posts on
spacer board (Fig. 17).
Make sure rail brackets are centered on posts.
Drive two (#10 x 2") mounting screws into
brackets and into posts, starting with the bottom
rail (Fig. 18). Repeat for each bracket. Screw
holes are angled inwards to provide clearance for
the drill chuck. Removal of the bottom stair tread
is not required.
Two screws (#10 x 1") per bracket are driven
under the top rail (Fig. 19). Holes are angled to
allow an extension bit to clear balusters.
NOTE:
Screws are not required in the bottom of the
bottom rail.
Fig. 16
Fig. 17
Fig. 18
Fig. 19
Lock TabsLock Tabs
Outer Edge Outer Edge
HolesHoles