Installation Guide

Assemble your stair railing section

a. Lock tabs on baluster/spindle must face outer edge of routed holes in rails.

b. Assemble your stair section by snapping balusters/spindles in rails.

c. Place brackets on ends.

d. Place assembled stair rail between posts on spacer board.

Lock tabs

Outer edge holes

Make sure rail brackets are centered on posts. Drive two (#10x2") mounting screws into brackets and into posts, starting with the

bottom rail. Repeat for each bracket. Screw holes are angled inwards to provide clearance for the drill chuck. Removal of the

bottom stair tread is not required.

Two screws (#10x1") per bracket are driven under the top rail. Holes are angled to allow an extension bit to clear balusters.

(NOTE: screws are not required in the bottom of the bottom rail.)