Installation Guide

8
ENGLISH
LED DOME LIGHT INSTALLATION
Crossover Product transformer, harnesses, and splitters are compatible with all Crossover Product lighted accessories (post caps, side/stair
lights, dome lights, under-rail lighting, and ush-deck lights) and Transform lighted accessories (Transform post caps, Transform dome lights).
1.
Cut out the template below and place at the
desired location. Pre-drill two /
16
" holes for
screws and one ½" hole for the wire.
Run a harness (not included) down the
inside of the post or post wrap with the male
connector hanging out of the ½" hole that
was just drilled.
2.
Plug the male connector into the female
connector attached to the light.
Press rmly until the connection is fully
engaged. The light should be illuminated if
the transformer is on.
3.
Twist the dome light to separate the dome
from the lens back. Push the wire and
connection of the lens portion back through
the ½" hole until the back plate of the light is
ush with the post (Fig. 1).
Align the pre-drilled holes and use the 2
included stainless steel screws to mount the
back plate of the light to the post (Fig. 2).
Place the dome/lens portion of the light over
the back plate at a slight angle. Place the
dome/lens portion over the back plate.
Once the dome/lens portion of the light is
ush with the post, twist the dome/lens
clockwise until it locks into place.
Follow instructions for wiring harness so that there is a male connector at each location that will have a light installed.
(Fig. 2)
(Fig. 1)
TEMPLATE
Cut out template to lay
against post for pre-drill hole
placement.