Installation Guide

5
ENGLISH
1.
Wire Harnesses:
The harness is used to extend power from
the transformer to each individual light or
splitter. The harness has a male and female
end (Fig. 1).
Harnesses can be plugged into each other to
extend length if needed (Fig. 2).
The harness can be run underneath the deck
(above ground) and/or inside the post/railing
where it is hidden from view.
2.
2-Way Splitter:
The 2-Way Splitter is used to evenly distribute
power from 1 input to 2 outputs.
Plug the male connector from a harness
into the female input connector of the
2-Way Splitter (Fig. 3). Press rmly until the
connection is fully engaged.
Plug the female connector from a harness or
a light into one of the male output connectors
(Fig. 4). Repeat for the other output
connector.
3.
5-Way Splitter
The 5-Way Splitter is used to evenly
distribute power from 1 input to 5 outputs.
Plug the male connector from a harness into
the female input connector of the 5-Way
Splitter. Press rmly until the connection is
fully engaged.
Connection is fully engaged when there
is minimal gap between the male harness
connector and the female input connector.
Plug the female connector from a harness
or a light into one of the male output
connectors. Repeat for each output
connector that is needed.
If there are any unused output connectors,
an end cap (2 included) must be used to seal
the output connector (Fig. 5). Any unused
end caps can be saved or discarded. If there
are more than 2 unused output connectors,
a 2-Way Splitter (Fig. 4) should be used.
The 5-Way Splitter can be secured using (2)
#2 Stainless Steel Screws (not supplied).
CONNECTING WIRE HARNESSES
(Fig. 2) (Fig. 4)
(Fig. 3)
(Fig. 1)
(Fig. 5)
Male connector
Female connector