Installation Guide

8
545 Tilton Road, Egg Harbor Twp, NJ 08215 | 877.420.7245 | sales@finyl-line.com
Fig. 2
Fig. 3
Fig. 4
Fig. 5
3
1
5
Assemble Your Stair Railing Section:
a. Kit comes with two balusters with lock tabs on end. Install
those two balusters on the ends closest to posts
b. Assemble your stair railing section by snapping balusters into
bottom rail (Fig. 2)
Stabilize Section:
a. Place assembled stair railing section adjacent to mounted stair
posts, leaving equal distances from the ends of both balusters
and clamp your stair railing section to the posts (Fig. 3).
b. Trace the post onto each rail (both ends of top and bottom
rails). Make four marks in total being sure to mark
1
⁄8" shorter
to allow for expansion (Fig. 4).
Cutting Rails:
Remove clamped stair kit from posts. Cut along all four angled
marks on rails (Fig. 5).
1
⁄8"
Clamp
I. Using pre-molded brackets: