Use and Care Manual

12
Assembly - Attaching the Light Kit
Attaching the light kit tter
assembly
Installing the bulbs and the
glass bowl
11 12
□ Remove the three screws from the black bracket below the
fan motor assembly (D).
□ Remove the hex nut and lockwasher from the top of the
light kit tter assembly (I).
□ Attach the light kit tter assembly (I) to the switch cup (E)
by rst removing the plastic plug (PP) in the bottom center
hole of the switch cup (E). Insert the wires from the top of
the light kit tter assembly (I) through the center hole in
the bottom of the switch cup (E) secured with the hex nut
and lockwasher removed in the second step.
□ Connect the wires from the light kit to the blue and white
wires in the switch cup (E) marked for light kit connection,
see Assembly section 6 on page 9 for wiring.
□ Connect the wires from the switch cup (E) to the wires
from the black bracket below the fan motor assembly (D)
by connecting the molded adaptor plugs together. Carefully
tuck all wires and splices in the switch cup (E).
□ Position switch cup (E) on the black bracket below the fan
motor assembly (D) and align the three holes in the black
bracket.
□ Re-install the three screws removed in rst step in this
section to secure the switch cup (E).
□ Remove the bottom cover and nial from the threaded
nipple of the light kit tter assembly (I).
□ With power off, install the two CFL bulbs (Max. 14W,
included) (K) by screwing them into the light bulb sockets.
□ Position the glass bowl (J) over the threaded nipple.
□ Re-install the bottom cover to the threaded nipple to secure
the glass bowl (J) properly.
□ Re-install and tighten the nial.
□ Attach the pull chain extensions (FF) provided to the light
pull chain and the fan pull chain.
WARNING: To reduce the risk of electric shock, disconnect
the electrical supply circuit to the fan before installing the
light xture.
WARNING: To reduce the risk of electric shock, disconnect
the electrical supply circuit to the fan before installing the
light xture.
CAUTION: Do not over-tighten the hex nut. Over-tightening
the hex nut may cause the glass bowl (J) to break.
D
E
I
PP
RR
FF
E
I
J
K
NOTE: Notice the location of the fan’s reverse switch (RR).
This is the switch used to change the fan’s directional
rotation. For more information on the operation of this switch,
see Operating Your Fan on page 13.