Use and Care Manual

READY-MIXED COLOURS: You only need to stir it a little before adding the hardener.
PERSONALIZED COLOUR: Pour all of the tint in the epoxy resin container (component A). Mix, scraping the sides
and bottom of the bucket to get a homogeneous colour. If a coat requires more than one 4.5 L container, mix the
containers together in a 5-gallon pail and pour back into the original containers according to volume.
IMPORTANT! Colour variations may occur if tinting, mixing and application procedures are not followed.
Stir each component separately. Pour all the hardener (component B) in the epoxy resin (component A). Mix well
for 4 minutes at a low speed (300 to 450 RPM) using a drill fitted with a mixer. Do not mix at a high speed
to prevent air entrapment bubbles. Scrape the sides and bottom of the bucket frequently with a stir stick to get
a homogeneous mixture. Let the mixture stand for 2 minutes. Apply all of the mixture within 30 minutes.
IMPORTANT! Mixing must be done properly in order for the hardener to have a uniform effect. The product
must be applied within 30 minutes of mixing.
TINTING (BEFORE ADDING THE HARDENER)
MIXING
APPLICATION
Pour the product directly onto the floor in consecutive and parallel strips. Using a brush, quickly cut in the edges.
Then, using a squeegee, spread the product and back roll (left to right, then toward you). It is important to get
a uniform coating and avoid puddling.
RECOMMANDATIONS
• Do not touch up the product after 10 minutes.
• Wear spiked shoes to walk on the coated surface.
• Apply a coat of clear epoxy on dark or metallic colours.
• Apply a second coat between 24 and 48 hours later to get a very glossy and uniform finish. If the second coat
must be applied more than 48 hours later, sand the surface using a sander fitted with 60-grit sandpaper
in order to remove the gloss and avoid any adherence problems.
On vertical or sloped surfaces, apply THIN COATS of the product to prevent sagging.
IMPORTANT! The product will start to cure quickly after 40 minutes and will be completely unusable after
50 minutes.
ANTI-SKID SAND AND DECORATIVE FLAKES: To get an anti-skid surface, sprinkle quartz sand evenly within
60 minutes of applying epoxy. Back roll (left to right, then toward you).
Use the same technique to add decorative flakes. Apply an additional coat of clear epoxy to prevent the flakes
from chipping.
Page 3 of 4