Use and Care Manual

AMOUNT OF DECORATIVE FLAKES BASED ON DESIRED HIDING LEVEL/100 SQ. FT.
Hiding level Approximate percentage Approximate quantity
Very light 2% 0.3 lb. 0.125 kg
Light 5% 0.7 lb. 0.3 kg
Medium 12.5% 1.75 lb. 0.8 kg
Intense 25% 3.5 lb. 1.6 kg
Very intense 50% 7 lb. 3.2 kg
Complete 100% 15 lb. 7 kg
FOR MORE INFORMATION, VISIT OUR WEBSITE!
www.epoxytogo.com
Allow a minimum of 24 hours before permitting foot traffic and a minimum of 48 to 72 hours before permitting
vehicles on it. The temperature and humidity will affect the curing time.
Clean all tools with xylene immediately after use. Always keep your goggles and gloves on to avoid any contact
with the product.
IMPORTANT! Once the product has cured, it can only be removed mechanically.
RESTRICTIONS
• Make sure that the temperature of the substrate is between 10°C and 30°C, and that it is at least 3°C above
the day’s dew point.
• Make sure that the humidity level of the substrate is below 4%. Do not apply the product on humid substrates
or porous surfaces that may absorb humidity from the soil.
• Maintain a relative humidity of maximum 85% during application and curing.
• Protect from humidity, condensation and water during the 48-hour curing period.
• Do not apply outside.
• The surface can become discoloured in places that are regularly exposed to UV light.
WARNING Always wear safety goggles, nitrile gloves and long sleeves and pants to avoid any contact
with the product. If skin contact occurs, wash immediately with warm soapy water and rinse thoroughly.
CURING TIME
CLEANING