User manual

• If you sell or pass on this product to a third party, always include these Direc-

tions for Use.

• Observe also the safety instructions in the individual sections of these Operat-

ing Instructions.

• The product must not be exposed to extreme temperatures, direct sunlight,

humidity, intense vibration or heavy mechanical strain. This could lead to mal-

function or a defect.

• Never place the product on an unstable surface. It will cause injury if allowed

to fall.

• Never turn on the product immediately after it has been brought from a cold

room into a warm one. The condensation water produced as a result could

destroy the product. Allow the appliance to reach room temperature before

switching it on. Wait until the condensation water has evaporated.

• Handle the product with care. It can be damaged by impact, blows or when

dropped even from a low height.

• The product must not be used if defective either in whole or in part. It may only

be repaired by a qualiﬁ ed person.

• Make sure that the product is not exposed to dust, dirt, oil or grease.

• The product should always be used in a well ventilated area. Never operate

the product when it is covered.

• If it can be assumed that safe operation is no longer possible, the device

must be turned off and precautions are to be taken to ensure that it is not

used unintentionally.

• The mains adapter must not be plugged in or pulled out with wet hands.

• Never pull on the cables of the wall power supply. Always pull the wall power

supply out of the mains socket by the housing.

• When setting up the product, make sure that the mains cable is not squashed

or damaged by sharp edges.

• Remove the power unit from the wall socket if the product is not in use for a

longer period of time.

• Always pull the wall power supply out of the mains socket before cleaning

the product.

• For safety reasons, disconnect the mains adapter from the mains socket dur-

ing thunderstorms.

• If you have questions which remained unanswered in these operating instruc-

tions, please contact our technical customer service.