Datasheet

Page 4 of 7 QR-QE-20/2003.08.01
8
Insulation
resistance
絕緣阻抗值
More than 100 MΩ
100 MΩ以上
Apply 250VDC to the individual terminals
and case.
金屬外殼與端子間加 DC250V 電壓
9
Withstand
voltage
耐電壓特性
Without arcing or breakdown
無損壞或弧光
Apply one minute of 250VAC to the
individual terminals and case.
在特定端子與外殼間加 AC250V 電壓 1 分鐘 .
二、MECHANICAL CHARACTERISTICS 機構特性
序號
NO.
項 目
ITEM
性 能
PERFORMANCE
測試條件
TEST METHODS AND REFERENCE
1
Figure of lever
operation
搖杆動作形式
Circular operating
圓形式
/
2
The stopper
strength of
the lever
搖杆止動強度
More than 3.1Kgf
3 seconds min
大於 3.1Kgf，至少 3 秒鐘
Apply side force on the lever perpendicular
to the lever’s axial direction..
垂直於搖杆的力作用於搖杆上.
3
Pull strength
of lever
搖杆拉拔強度
More than 5.0 Kgf
3 seconds min
大於 5.0Kgf，至少 3 秒鐘
Apply specified pull force on the lever
upward.
作用於搖杆上，沿搖杆方向向上.
4
Push
Strength of
lever
搖杆推強度
More than 3.0 Kgf
3 seconds min
大於 3.0Kgf，至少 3 秒鐘
Apply specified push force on the lever
downward.
作用於搖杆上，沿搖杆方向向下.
5
Operating
force of
lever
搖杆作用力
110±40 gf.cm
Test position： More than 10 degrees
deflection of lever.
搖杆偏斜 10 度以上之位置測定.
6
Accuracy of
reset
position of
lever
搖杆復歸精度
±5°
Measure the angle between the lever and
the axial center line after the lever
pushed to the direction of X-X(Y-Y) and
resets.
搖杆推向 X-X(Y-Y)方向自由復歸後測搖
杆與垂直中心線的角度.