Datasheet

Page 6 of 7 QR-QE-20/2003.08.01
5
Temperature
cycling test
溫度循環測試
The total resistance change
should be within ±20%.
To be operated mechanically.
全阻值變化要在±20%以內，
機械方面能動作。
Low temperature : -10 ±3℃ 30 minutes
High temperature: +60 ±2℃ 30 minutes
Number of cycles: 5
Surface moisture shall be removed, and
then the controller shall be subjected
to standard atmospheric conditions
for 2 hours after which measurement
shall be made.
在低溫為-10 ±3℃放置30分鐘,高溫60 ±
2℃放置 30 分鐘,測試 5 次.表面水份攝取
后 2 小時后正常狀態下測試.
6
Resistance to
soldering
焊錫性
Not less than 3/4 of the surface
dipped shall be covered with new
solder.
浸錫部分表面最少 3/4 被新錫覆蓋 .
Temperature of solder: 235±5℃,
Dipping duration:3±0.5S.
焊錫溫度：235±5℃,
浸錫時間：3±0.5 秒.
7
Resistance to
soldering heat
焊錫耐熱性
Variation of total resistance shall
be within ± 5%, and terminals
shall not work loose to injure
electric contact, after test.
全阻值變化±5%以內,測試後無端
子鬆動,不會損壞電氣接點。
Soldering temperature 260±5℃ for 5 sec.
焊錫溫度 260±5℃,5 秒.
8
Number of
cycles
耐久次數值
Total resistance ≦ Initial value ± 20%.
No mechanical malfunction.
全阻值變化≦初始值±20% .
機械方面能動作.
1,000,000 Cycles min
四、SWITCH CHARACTERISTICS (FOR WITH-SWITCH TYPE)
開關規格(適用於帶開關機種)
序號
NO.
項 目
ITEM
性 能
PERFORMANCE
測試條件
TEST CONDITIONS
1
Operating
force
作動力
820 ± 260 gf.cm
Apply side force perpendicular to the lever’s
axial direction on the lever until the lever
stops, measure the max force value.
將一個軸向力施加於搖杆上直到其不動
為止,量取施力期間之最大值.