2INCH-GUN METAL DESK FAN Operating and Safety Instructions 99397 FOR INDOOR HOUSEHOLD USE ONLY
IMPORTANT SAFEGUARDS Definitions Whenever used, the following identify safety and property damage messages and designate a level of hazard seriousness. - This is the safety alert symbol. It alerts you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death. DANGER – Indicates a hazardous situation, which, if not avoided, will result in death or serious injury. Usage of this signal word is limited to the most extreme situations.
• Unplug power cord whenever fan is not in use. Do not leave fan unattended while it is plugged in. • Do not immerse the product, power cord, or plug in water or other liquids. Do not place the product in or near an open window as precipitation may enter the product and cause electrical short-circuiting. • To disconnect the product from an electrical outlet, turn any control to the Off position and then pull directly on the plug; do not pull on the power cord.
Parts 1. 2. 3. 4. 5. 6. Fan blade Fan grill(front+rear) Motor housing Oscillation button Speed control knob Powercord&plug To Assemble - - Remove the 4pcs screws form the motor pain. Fit the rear cage onto the motor pain. Make sure that the 4 holes on the motor match the 4 holes on the rear cage. Fit the 4pcs screw and screw it on firmly. Put the blade on the motor pain and carefully tighten the screw. Fit the front cage onto the rear cage and fix them together using the metal clips.
The fan can operate in oscillating or stationary mode. Press the oscillation button to activate the oscillating mode. CLEANING - Always switch the fan off and unplug it before cleaning. - Clean the parts using a damp cloth and a mild detergent, and ensure that all detergent residues is removed. - Never use abrasive cleaning agents or solvents. - Do not immerse in any form of liquid. WARNING: Always unplug the product from the outlet when not in use or if it will be left unattended.