User manual

37
9. Commissioning
a) Remove Car Body
Pull the two safety clips out and take off the car body upwards.
b) Installing the Receiver Aerial Cable
Route the aerial cable through the enclosed aerial tube
and plug it into the corresponding holder between the
chassisandtheservo/receiver;seearrowinthegureon
the right.
For a wide range, the aerial needs to protrude from the
vehicle as vertically as possible.
Ensure that the aerial cable is not damaged.
Never shorten the aerial cable! Never coil the
aerial cable! This greatly reduces the range!
c) Conguring the Speed Controller
The speed controller has two jumpers to congure the
driving function and the rechargeable battery type.
Jumper "Reverse" (A): This switches reverse driving off
("Disable") or on ("Enable").
Jumper "Battery" (B): Sets which drive battery is connect-
edtothespeedcontroller(LiPoorNiMH).
Important!
Ifyouuse a LiPodrivebattery butsetthe re-
chargeablebatterytypetoNiMH,therecharge-
able battery will be deep discharged and de-
stroyed.
Therefore, always set the proper rechargeable
battery type before operating the vehicle.
Thesetting"Lipo"causesthespeedcontroller
to reduce the motor power to 50 % when the
battery voltage drops below 6.5 V.
The speed controller switches off the motor be-
lowabatteryvoltageof6.0V.Thisway,theLiPo
drive battery is protected from harmful deep dis-
charge.
A
B
A
B