Installation Guide

INSTALLATION TIPS
Installation of the AC Window Guard shall follow and comply with the requirements
of all applicable local, state, federal and othere authorities having jurisdiction in your
area. Contact your local building department or fire department for specific codes that
may apply in your area.
• Installer must use tamper resistant screws (provided). All screws must be anchored
firmly into a solid stud or frame material for proper operation of guard.
• Upon the installation of the window guard there should be no tampering or removal
of the AC Window Guard.
Please read the Installations Instructions (provided) and product specifications to
ensure AC Window Guard is properly installed.
WINDOW SAFETY TIPS
• Window falls can happen in the blink of an eye. Always supervise children near open
windows.
• Don’t place furniture near windows that children may climb.
• Window screens are not strong enough to prevent falls.
• Teach children not to play with, climb, or open windows.
• Upon the removal of air conditioner units it is mandatory to install the L angle stops
(provided) to prevent children from opening the window and climing into the
AC Window Guards.
INSTALLATION INSTRUCTIONS
Single/Double Hung Windows
Step #1: Open the window (prior to opening the window make sure children
are not around).
Step #2: place AC Window Guard in the window opening and stretch open
the guard until both end posts are inside the window rail.
Step #3: Drill holes for end post by lining up drill bit with center of pre-cut
openings on the end post (five openings on each side of end post).
(See: Fig. 1)