Installation Guide

ManualsBrandsUnbranded ManualsHardwareAir Conditioner Window Guard

I N S T A L L A T I O N

S A F E T Y

I m p o r t a n t s a f e t y p r e c a u t i o n s f o r p r o p e r u s e a n d c a r e o f A C

W i n d o w G u a r d s .

WARNING

Window guards are designed to be a deterrent to accidental window falls. This

product is not intended as a substitute for proper adult supervision.

Failure to follow all of the manufacturer’s installation and safety instructions

may reduce the effectiveness of the guard and increase the risk of accidental

window falls.

This window guard is intended to protect against potential falls by children age

5 and under.

AC Window Guards are not meant to protect children from intruders.

INSTALLATION TIPS

Before installation, consult building and fire codes. Contact local building code

department or fire department for specific codes that may apply in your area.

Summary of content (6 pages)

PAGE 1
INSTALLATION & SAFETY Important safety precautions for proper use and care of AC Window Guards. WARNING Window guards are designed to be a deterrent to accidental window falls. This product is not intended as a substitute for proper adult supervision. Failure to follow all of the manufacturer’s installation and safety instructions may reduce the effectiveness of the guard and increase the risk of accidental window falls.
PAGE 2
• • • All screws must be anchored firmly into a solid stud or frame material for proper operation of guard. There should be no open spaces in the guarded area or window opening exceeding 4 inches. Parents, caregivers, and older children must understand the operation of this window guard in case of an emergency. Refer to installation instructions and product specifications to ensure window guard is properly installed. WINDOW SAFETY TIPS • • • • • • Window falls can happen in the blink of an eye.
PAGE 3
INSTALLATION INSTRUCTIONS Single/Double Hung Windows Step #1: Open the window (make sure children are not around). Step #2: place AC Window Guard in the window opening and stretch open the guard until both end posts are inside the window rail.
PAGE 4
Step #3: Drill holes for end post by lining up drill bit with center of pre-cut openings on the end post (five openings on each side of end post). Step #4: Fasten end post to window rails using the ten screws provided. Screws must be fasten into a solid stud or frame for guard to work properly. Step #5: After end post are securely installed test the AC Window Guard by pulling each end towards the center of window and towards you.
PAGE 5
PAGE 6
AC Window Guard is a registered trademark of AC Window Guard LLC. United States patent number 9388999 AC Window Guard LLC. P.