Replacement Part List

45
Chapter 3: Q&A
Q1. How to solve if the nozzle is clogged？
Q2. How to replace the nozzle ?
Power off before replacing nozzle! Make sure power off operation!
Please make filament tip smooth and flat when cutting off the filament.
Whether the assembly of the sprinkler is in place is judged as follows:
1. When installing, must press the sprinkler hard to the end.
2. Check whether the installation is in place:
( 1 ) Touch the black buckle and white sprinkler's lower shell, make sure
no sunken.
( 2 ) Look at the black buckle and white sprinkler's lower shell, make sure
there is not a large gap in the contact.
Notice
Clips
Method 1: Tap [Preheat], heat up the extruder to 240℃, after heating completed, press the air
tube joint and pull out the filament guide tube. Check to see whether the filament is
bended or filament tip is not smooth, cut filament tip smooth and flat, install the
guide tube and filament back, Tap [Load] .
Method 2: If method 1 not improving, use an unclogging pin tool to unclog filament.
Method 3: If method 1 and method 2 not improving, please replace the nozzle.
1. Press the left and right clips and pull out the nozzle.
2. Push in a length of filament through the filament intake manually, making it long enough to
be cut off.
3. Rotate the filament spool anti-clockwise manually, making filament retreat back a little.
4. Press the left and right clips, install the new nozzle back into the extruder, making the nozzle
slot and bottom of extruder are on the same level.
5. Tap[Filament] -- Tap[Load], nozzle replace completed when you see filament come out of
new nozzle.
The buckle is not installed in place The buckle is installed in place