Installation Guide

Table Of Contents

Install Instruction

Tip:Please put the connected part into the 70~80°water for 10seconds before assmbling.

It will be easier to install.

 Step 1: Cut the water pipe accordingto the length you need.

 Step 2: Connect the tee.

 Step 3: Connect tee with the atomizingnozzle.

 Step 4: Connect an end closure whenyou finish all atomizing nozzles’ installation.

 Step 5: Connect the pipe to tubing quickconnector.

 Step 6: Connect the tubing quickconnector with the universal connector.

PAGE 1
Install Instruction Tip:Please put the connected part into the 70~80°water for 10seconds before assmbling. It will be easier to install.       Step 1: Cut the water pipe accordingto the length you need. Step 2: Connect the tee. Step 3: Connect tee with the atomizingnozzle. Step 4: Connect an end closure whenyou finish all atomizing nozzles’ installation. Step 5: Connect the pipe to tubing quickconnector. Step 6: Connect the tubing quickconnector with the universal connector.