Installation Guide

SKU # Selling Unit
BLS10 Bag of 10
Max. Voltage: 15V max. building wire, 10AMPS
Connector Size: 2” x 1.5”
Wire Type: Copper/Copper
Wire Range: Large Hole Min #14/Max #12
Small Hole Min #20/Max #16
Temperature Rating: 105°C (221°F)
Silicone Sealant Temperature: -40°F to 400°F
INSTALLATION INSTRUCTIONS
PRODUCT SPECIFICATIONS
& MEASUREMENTS
Measurements (Inches):
A - 1.922
B - 1.522
C - 1.355
Blazing
TM
BLS10 SnapLoc Waterproof Connectors
50100-119 REV A 03/18
IMPORTANT: Turn off power before
installing or removing connector. Product
to be used in accordance with local and
national codes.
1. Strip wires to 11/16”.
Use one of the strip
guides molded into
the connector for
reference. Pre-twist
stranded wires.
2. Rotate handles
fully apart beyond
90 degrees. Insert
stripped wires into
connector; #12-#14
in the large holes
and #16-#20 in the
small hole. Exposed
ends of wires should
be visible through
the clear housing on
the back.
3. Hold wires in place
while squeezing
handles together
until the latch snaps
shut.
S
t
r
i
p
S
t
r
i
p
1
S
t
r
i
p
S
t
r
i
p
Visible
Ends of Wires
2
3
Selected 15V Wire Combinations
For use with stranded combinations.
Contact factory for a complete list of wire combinations at 800.633.0232.
Filled Connectors for Outdoor/Electrical Use
www.kinginnovation.com
(P) 800.633.0232
(F) 636.519.5410
U.S. Pat. 7,335,050, D575,738, D575,230, and
other patents pending.
Large Hole Min #14/Max #12 Small Hole Min #20/Max #16