Installation Guide

4
Installation and Operation Guide
www.blueairfse.com
3) Assembling casters:
(1). Reach-ins (Figure3): Install casters in the bottom rails
assembly on the bottom of the unit. It is important in
order to achieve maximum strength and stability of the
unit that you ensure that each caster is securely
tightened with a 3/4" (19mm) open-ended wrench.
Casters with brakes Must
be installed in front. and the
casters must be in contact firmly with the bottom rails of
the unit.
(2) Undercounter and Tables (Figure4): Install casters in
the bottom rails assembly on the bottom of the unit with 4
M6 bolts for each caster. This is required in order to
achieve maximum strength and stability of the unit.
Casters with brakes Must
be installed in front and the
casters must be in contact firmly with the bottom rails of
the unit.
4) Leveling:
Proper leveling of your Blue Air unit is critical to
operating success. Effective condensate removal
and door operation will be effected by leveling.
1) Reach Ins; The unit should be leveled front to
back and side to side with a level. For unit with
casters Models: Four shims have been provided
in the caster package for leveling unit with casters
units positioned on uneven floors. Shims must be
positioned between rail end and bearing race.
• If the cabinet is not level, use a 3/4" (19mm)
open-end wrench to turn the anchoring bolt
under the bearing race counter-clockwise until
the cabinet is level.
• Install the desired number of shims, making sure
the slot of the shim is in contact with the
threaded stem of the caster.
• If more than one shim is used, turn the slot at a
45° angle at least so they are not in line.
• Turn the anchoring bolt clockwise with a 3/4"
(19mm) open-end wrench to tighten and secure
the caster
• Ensure that the drain hose or hoses are
positioned in the condensate water pan.
• Untangle plug and cord from unit (do not plug
unit into power supply while leveling).
• The unit should be placed close enough to the
electrical supply so that the extension cords are
never used.
Warning: Warning Compressor warranties are
void if the unit is more than 6-1⁄2 ft. (2m) from
plugin connection.
Caution
To avoid damage to lower rail assembly, raise
unit slowly and carefully to upright position.
2) Table Units: The unit should be leveled front to
back and side to side as shown
Figure 3
Figure 4