Installation Guide

5
Installation and Operation Guide
www.blueairfse.com
7) To connect electricity :
The power cord of this appliance is equipped with a
grounding plug which mates with a standard grounding
wall outlet to minimize the possibility of electric shock
hazard from the appliance.
Do not, under any circumstances, cut or remove the
ground prong from the power cord.
For personal safety, this appliance must be properly
grounded.
Have the wall outlet and circuit checked by a qualified
electrician to make sure the outlet is properly grounded.
If the outlet is a 2-prong outlet, it is your personal
responsibility and obligation to have it replaced with the
properly grounded wall outlet before using the unit.
A 3-prong outlet ensures the best performance and also
prevents overloading building wiring circuits which
could cause a fire hazard from overheated wires.
Never unplug your refrigerator by pulling on the power
cord.
Always grip plug firmly and pull straight out from the
outlet.
Repair or replace immediately all power cords that have
become frayed or otherwise damaged. Do not use a
cord that shows cracks or abrasion damage along its
length or at either end.
Plugs used depending on unit
1) NEMA Plugs
NEMA-5-15R, 115V/60/1
2) Make sure the power cord is connected to the
proper voltage. (Rated ±10%)
3) Compressor warranties are void if compressor burns
out due to usage of improper voltage.
4) A protected circuit of the correct voltage and
amperage must be used.
5) Turn ‘off the power switch before disconnecting the
power cord whenever performing maintenance
service or cleaning the refrigerated cabinet.
6) If the power cord of Refrigerator (Freezer) is
damaged, it should be replaced by the manufacturer
or service agent or a similarly qualified person in
order to avoid a hazard.
7) If unit is disconnected, wait 5 minutes before re-
starting.
“If you have any questions about set up or installation
of your refrigerator, call our technical service”
5) Ventilation:
Set unit in its final location. Be sure there is
adequate ventilation in your room. you may need to
install an exhaust fan under the extreme heat
conditions, (100°F+, 38°C+),
Warning: Warranty is void if ventilation is
insufficient.
6) Space clearance:
Ensure air circulation around unit
7) Assemble shelf clips :
• Install all the shelf clips before installing the
shelves.
1) Put the tap back side of clip into the hole of the
pilaster.
2) Rotate the clip with 180 degree.
• install the clips as shown above then install
shelves.