Installation Guide

8
Installation and Operation Guide
www.blueairfse.com
4) Cleaning the cabinet.
To reduce the risk of electric shock, unplug before
cleaning or service”
A. Cleaning the interior and exterior
• The interior and exterior of the unit can be
cleaned using warm water with soap.
• Do not use an abrasive cleaner because it will
scratch the surface.
B. Cleaning the gasket
• The door gasket should be cleaned frequently to
maintain proper sealing.
• Use warm water and a mild soap.
C. Cleaning the evaporator
• If you need to clean the evaporator, please
contact the qualified service technicians.
D. Check after cleaning
• Check the unit again for safety.
• Check if the unit is operating properly.
Tips that help prevent rusting on stainless steel
Use soft cloths or plastic scouring pads the will not harm
the stainless steel’s passive layer.
• Use the correct cleaning tools.
When cleaning your stainless steel products that make
sure to use non-abrasive.
• Cleaning along stainless steel finish line.s
Always scrub parallel to visible lines on stainless
steels. Use a plastic scouring pad or soft cloth when
you cannot see the grain.
• Use the cleaners that are either Alkaline, Alkaline
chlorinated or Non Chloride based.
Avoid cleaners containing quaternary salts as they can
attack stainless steel, causing pitting and rusting.
• Water Treatment.
It is recommended to use soft water when possible to
reduce deposits. Installation of certain filters can
remove corrosive and distasteful minerals.
Talk to a water treatment specialist if you are not sure
of the proper water treatment.
• Clean your equipment frequently
3) Reach ins (top mounted compressor unit):
• Take off top grille at the bottom by removing screws
(only reach-in top mounted compressor model)
• Clean off accumulated dirt from condensing coil and
fan blades with a soft brush.
• Reinstall cover onto unit. Make tighten all screws.
• Plug the unit to power and check if compressor and
fan is working.