HushTone Bathroom Exhaust Fan Installation and Operation Instructions Please read all instructions before installing and operating. All wiring and installation must be in accordance with CEC, NEC and local electrical codes.
Bathroom Exhaust Fan Installation- English
IMPORTANT SAFETY INSTRUCTIONS WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: a). Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer. b). Before servicing or cleaning unit, switch power off at service panel and lock the service disconnecting means to prevent power from being switching on accidentally.
BATH FAN INSTALLATION - TOOLS AND MATERIALS REQUIRED • • • • Electrical drill or ratchet driver ½” drill bit for drilling pilot holes 1 ¼” drill bit for drilling electrical wiring access hole (if applicable) Phillips screwdriver #2 or driver bit • • • Wire stripper or cutter Aluminum foil tape and/or duct tape Electrical supplies for wiring (i.e. marrets, electrical tape) PARTS SUPPLIED 1 × Fan 1 × Grille Assembly (Includes 2 × Grill Spring) 4 × Mounting Bracket PLAN THE INSTALLATION 1.
INSULATION* (Place around and over Fan Housing.) ROOF CAP* (with built-in damper) FAN HOUSING POWER CABLE* Keep duct runs short Seal gaps around Housing. ROUND DUCT* * Purchase separately Seal duct joints with tape. WALL CAP* (with built-in damper) ROUND ELBOW(S) * ROOF EXHAUST OR SIDE WALL EXHAUST Note: For best performance, use the shortest, straightest duct routing possible and avoid installing with smaller ducts than suggested. INSTALLATION STEPS 1. REMOVE PACKAGING AND SWITCH OFF POWER 2.
FOR TRUSS MOUNTING DUCT Step 1: Snap the damper/duct connector onto the fan housing. The connector must be flush with the top of the housing, and the damper flap should fall closed. Optional: Insulated flexible duct is recommended for the quietest possible installation. If rigid duct is used, a short (1-3 feet) section of insulated flexible duct will ensure quiet operation. * FOR MODEL CB50, PLEASE READ ADDITIONAL STEPS Snap-in ans secure housing. 3.
OPERATION Use an on/off switch to operate this fan. See “Connect Wiring” for details. CLEANING & MAINTENANCE For quiet and efficient operation, long life, and attractive appearance - lower or remove grille and vacuum interior of unit with the dusting brush attachment. The motor is permanently lubricated and never needs oiling. If the motor bearings are making excessive or unusual noises, replace the motor with the exact service motor. The impeller should also be replaced.
TROUBLESHOOTING For additional service inquiries, contact Cyclone servicing department at 1-888-293-5662 or Service@CycloneRangeHoods.com ISSUE CAUSE Unit does not work after 1. installation. The power source is not turned ON. SOLUTION A. Ensure power is ON for the circuit breaker and unit. B. Check for an open fuse or circuit breaker in the building’s service panel. Plug-in connections for motor may be loose. 1.
CYCLONE HUSHTONE BATHROOM EXHAUST FAN LIMITED WARRANTY North America Range Hoods Inc. (hereunder called “The Company”) provides a warranty that its products are free from defects in workmanship and materials for a period of one (1) year from the date of purchase for the following models: C50, C90, CB50, CB80 and for a period of three years for the following models: ESCB80 (H/L/S/HL/HM/SL/SM), ESCB110 (H/L/S/HL/HM/SL/SM), CBD120 (H/L/S/HL/HM/SL/SM), ESCB150(H/L/S/HL/HM/SL/SM).
