Instructions / Assembly

CF1009 TETE-A-TETE PORCH SWING
2 - 3/8”
Washers
2 - Barrel
Nuts
4 - 1/4” x 5”
Hex Washer
Head Screws
2 - 3/8” x 5”
Eye Bolts
2 - S Hooks
Please check contents before assembly. If any items are missing or damaged, do not take the unit back to the
store. Call 1-800-427-5136 for customer service and we will save you time by correcting any problems directly
for you.
2 - Seat Ends
2 - 12”
Arm Supports
2 - 24” Arms
2 - 9-1/2” Front
Table Supports
Preassembled Swing Seat
2 - Preassembled Seat Backs
2 - 45” Swing
Bars
Table Top
NOTE: Cracks or Checks in logs are part of the natural
beauty of cedar logs and should not be considered defects.
TETE-A-TETE PORCH SWING COMPONANTS
NOTE:
Rubber
Mallet
Block of Wood
& Hammer
or
 Read all instructions before starting.
Helpful Tips:
 To start hex washer head screws, hammer into
wood about 1/2” then use wrench or socket to
tighten.
 Do not completely tighten any screws until the
unit is fully assembled and setting on a level
surface.
 If you have hardware left over after completing
your unit, it most likely has been assembled in-
correctly, and may not be safe to use. Please
call Customer Service at 1-800-427-5136, for
assistance.
 Check all nuts and bolts for tightness before
and during each usage season.
18 - 2” Screws
TETE-A-TETE PORCH SWING HARDWARE
TOOLS REQUIRED
(Shown smaller than actual size)
Tape
Measure
Pencil
Regular
Screwdriver
#2 Phillips
Screwdriver
7/16”
7/16”