Instructions / Assembly

Lucky Dog™ Food & Water Systems
Assembly Instructions
(recommend 2 people for easiest installation)
2/08
(recommend
2
people
for
easiest
installation)
Stationary Bowl system – CL 71121
Step 1 –
Open Box, ensure all hardware is included:
2 – Stainless steel bowls
1 – bowl support frame
1
attachment bar
1
–
attachment
bar
3 – Bolts & nuts
Step 2 – From the inside of the kennel,
hold the bowl support frame up
to the welded wire mesh at the
desired height. Insert the 3 bolts
in the holes provided.
Step 3
Step
3
–
On the outside, place the attachment bar
over the bolt ends, then apply the nuts
provided to each of the bolt ends and tighten firmly.
NOTE: Do not over tighten nuts.
Step 4 – Insert bowls into support frame and fill
with desired contents.
Rotating Bowl system – CL 71120
Step 1 –
Open Box, ensure all hardware is included:
2 – Stainless steel bowls
1
–
Rotatin
g
frame
Remove (10) 4”
vertical adjacent
wires by cutting
top and bottom of
the wire.
Eye Protection
g
2 – attachment bars
8 – Bolts & nuts
Step 2 – From the inside of the kennel, hold the bowl support
frame up to the welded wire mesh at the desired height.
To ensure the right side is up, the pull trigger lock pin
should pull UPWARD to open.
Eye
Protection
recommended
Step 3 - Once the correct height is determined, set frame aside.
You will need to remove the (10) vertical wires in that
area, using small bolt cutters (not included). Then, hold
the frame to align with the opening and insert the 8 bolts
in the holes provided. Place both top and bottom
attachment bars over the bolt ends and hold in place.
St 4
St
ep
4
–
Apply the nuts provided to each of the bolt ends and
tighten firmly.
NOTE: Do not over tighten nuts.
Step 5 – Insert bowls into support frame and fill with desired
contents.