Use and Care Manual
TM & © 2016 FABRIQUE INNOVATIONS INC. • SPORTICULTURE™
ALL RIGHTS RESERVED • MADE IN CHINA
DISTRIBUTED BY FABRIQUE INNOVATIONS INC., NEW YORK, NY 10018
INCLUDED COMPONENTS:
WEATHER
RESISTENT
HOUSING
ADJUSTMENT
KNOB
LAWN STAKE
TRIPOD
FOR INDOOR USE
ON/OFF
BUTTON
5V DC
POWER
SUPPLY
INSTRUCTIONS:
1. Determine proper placement of Light such that there is nothing blocking the
light and the surface to illuminate.
2. For outdoors: use included lawn stake. Insert lawn stake into ground/lawn at
dedicated location. Once lawn stake is rmly in the ground, attach Light
component on top.
Indoor use: attach included tripod.
3. Adjust to desired projection angle by using the black knob on the side of the
Light underneath component. Tighten again once correct angle is obtained.
4. Use outdoor extension cord (not included) to plug into power supply.
Extension cord to be plugged into a 120v/60h outlet.
5. To turn on Light press red button once on the back of Light component
(Light will be on rotation).
Pressing twice stops Light from rotating.
Pressing red button a third time turns Light o.
6. For safety purposes Light automatically shuts o after 8 hours
11. Do not dissasemble charger. Dissasembly may result in risk of electrical shock
or re.
12. To reduce the risk of electrical shock, unplug the charger from the outlet when
not in use.
13. Do not operate unit if it has been subjected to damage of any kind.
CAUTION: Avoid direct eye contact light. Never expose your eyes or others to
direct light.
SAFETY INSTRUCTIONS:
1. Always be cautious when using electrical products.
2. Read and follow all safety instructions.
3. Reference National Code, ANSI/NFPA 70, for installations of wiring and
clearances from power and lighting conductors.
4. Installation work and electrical wiring must be done by qualied person(s) in
accordance with all applicable codes and standards, including re-rated
construction.
5. For a direct plug-in unit, do not install or use within 10 feet of a pool/water.
6. Do not use in a bathroom.
CAUTION: RISK OF ELECTRICAL SHOCK. Do not use with extension cord near
water or where water may accumulate. Keep Light at least 16 feet away from
pools and spas. Keep plugs and receptacles dry.
7. WARNING: Risk of Electrical Shock. When used outdoors, install only to a
covered class A GGCI protected receptacle. If one is not available, contact a
qualied electrician for proper installation. Ensure that the power unit and
cord do not interfere with completely closing the receptacle cover.
8. WARNING: Risk of Fire. Installation involves special wiring methods to run
wiring through a building’s structure. Consult a qualied electrician.
9. This unit is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience or knowledge,
unless they have been given supervision or instruction concerning use of
Light by a person responsible for their safety. Children should be supervised
to ensure they do not play with the unit.
10. Do not operate with damaged plug.
FOR INDOOR AND OUTDOOR USE - RAINTIGHT RATING IP44
ADAPTOR VOLTAGE: AC 100-240V / 50-60HZ
INPUT VOLTAGE: DC 15V 1.2A
EACH LED POWER: 2.5W
COLOR TEMPERATURE: 6000K~8000K Cool White
OPERATION TEMPERATURES: -17F ~ 100F
PROJECTION DISTANCE: 25~50 FEET
SAVE THESE INSTRUCTIONS - This manual contains important safety and operating instructions for power units.
CAUTION: TO REDUCE THE RISKS ASSOCIATED WITH LED BRIGHT LIGHT - DO NOT
STARE DIRECTLY INTO THE PROJECTOR LENS
CAUTION: TO REDUCE THE RISK ASSOCIATED WITH INTENSE VISIBLE LIGHT - DO NOT
USE THIS PROJECTOR AROUND UNSUPERVISED CHLDREN
Do not block any ventilation openings. To ensure reliable operation of the projector
and to protect from over heating, it is recommended to install the projector in a
location that does not block ventilation. As an example, do not place the projector
on a crowded table, sofa, bed, etc. Do not put the projector in an enclosure such as a
book case or a cabinet that restricts air ow.
Do not install near heat sources such as radiators, heaters, stoves or any other
apparatus such as ampliers that emits heat.
Only use attachments/accessories specied by the manufacturer.
Do not attempt to service the unit yourself. Opening or removing covers may expose
you to dangerous voltages or other hazards.
If the projector fan fails, turn o the projector when overheated. Turn ON again after
the projector cools down.
Do not use the projector in direct sunlight.
Do not use near any appliance generating a strong magnetic eld.
Do not touch the projector for a long time while the projector is used.
Image is too small or too large
• Move the projector closer to or further from the screen
FCC statement:
This device complies with part 15 of the FCC Rules
Operation is subject to the following two conditions (1)
This device may not cause harmful interference, and (2)
This device must accept any interference, including interference that may cause
undesired operation
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment o and on , the user is
encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit dierent from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help