Full Product Manual

This system uses a sealed paper bag for ltration. The
mass of dirt and debris is picked up by your vacuum
and deposited into the lter bag inside your dirt canis-
ter. Bag #s: HPB1 & HPB2H
Emptying your Dirt Can
To remove accumulation, follow these steps:
1
2
3
Remove the lid by lifting straight up. There are no
hinges or clamps.
Remove the bag by sliding the rubber gasket
that surrounds the hole in the paper bag o the
plastic inlet stem that protrudes through the front
of the canister.
Once the bag is o of the inlet stem, seal the bag
by removing the backing from the tab and cover
the hole with the ap. Press the ap so that it
securely seals over the hole (Fig. 3). This will help
prevent dirt and dust from escaping. Now, lift the
paper bag from the dirt canister and place in a
suitable trash container.
Take a new bag and extend it fully (Fig. 4).
Place it in the canister, and slide its rubber gasket
onto the inlet stem until the rubber gasket drops
into place in the ridge that is around the inlet
stem (Fig. 5).
Carefully replace the lid onto the dirt canister to
ensure that it seals properly. Not doing so could
cause a vacuum leak and reduce the cleaning
eciency of your system.
1
2
3
4
5
If bag breaks...
In the event of a bag breaking while in the unit, it is
necessary to lift the plate located under the bag and
clean the small screen.
The lter bag should be changed or cleaned when there is 3-6 inches of dirt or
anytime there is a noticeable reduction of air ow at the cleaning tool.
HOW OFTEN SHOULD I CHECK OR EMPTY THE PAPER BAG?
?
Initially, the dirt canister should be checked or emptied weekly until some idea can
be obtained as to how long it takes to half ll the canister under your normal cleaning
routine. All vacuum systems will function more eectively if they are emptied
frequently. Under no circumstances should you allow your dirt canister to become more
than 3/4 full before emptying.
4
5
6
MAINTENANCE - Paper Bag
Installing a New Bag
Some units come
equipped with an internal
thermal switch. When
tripped it requires up to
10 (ten) minutes to reset
before using again.
5
www.centralvacuumstores.com 14