Full Product Manual
on and try to open the door of anoth-
er inlet, since this will tend to pull the
rubber gasket from the door. If inlet does
not have remote on/o hose activated,
leave door open for a few seconds after
removing hose from inlet so the cyclonic
ltration has time to shut down and debris
can settle back down into the dirt can.
If the power unit continues to run after
the hose is removed from the inlet, the
small ball which activates the low voltage
switch at the inlet should be checked to
make sure it has not become lodged in
some way. Should this not shut the unit
o, disconnect the electrical supply to the
power unit and notify your local dealer or
serviceman.
VACUUM POWER UNIT - Your power unit
does not require any oil. The bearings in
the motor are greased and sealed for life.
The motor of the unit has contact brush-
es inside. As the unit is used, the brushes
will wear, even when functioning proper-
ly. Because of this, the brushes in most
power units will need to be replaced
after 700 to 1,500 hours of use. Brush
life is also aected by humidity, altitude,
temperature and the number of starts
and stops. So, there is a wide spread
in the actual life of the motor brushes.
On average the life of the motor brush,
when used in a normal manner, will be
from ten to twenty years. The cost of re-
placing your motor brushes is not great;
but, the damage that can be done to the
motor through not replacing the brushes
before they are completely worn out is
considerable. We recommend that you
have your unit and motor brushes in-
spected by a qualied serviceman every
4-6 years.
OPERATING YOUR CENTRAL VACUUM
Your central vacuum system has been
engineered for a long, trouble-free ser-
vice life. Your power unit is covered by a
factory limited warranty that is enclosed
with these instructions. Please read your
limited warranty carefully and return the
warranty card. It is important that you ll
out your warranty registration card prop-
erly and mail it to the factory. You should
ll out your registration card within ten
(10) days of installation and mail it to
Central Vacuum Stores, 11236 47th St N
Clearwater, FL 33762. Remember, your
warranty does not cover abuse or misuse
of the equipment.
CLEANING TOOLS - Since there are
several tool kits available, the use and care
of these tools is explained in a separate
booklet packed with each of the tool kits.
It is very important to utilize the tool that
is designed to perform a particular clean-
ing job, in order to obtain full eciency
from your system. Each of the tools and
their designed use is explained in the
booklet packed with your particular tool
kit. Also, other special carpet & ooring
tools are available, which are not included
as part of the normal tool kits. A few of
these are a vibrating upholstery tool, a
pet grooming tool, and a hand held air
turbine. In addition, there are accessories
designed to allow you to safely pick up
liquids with your cleaning system such as
the Wet Pick-Up. Each of these tools is
available for purchase from Central Vacu-
um Stores; if you would like to know more
about a certain tool, please contact them.
VACUUM INLETS - When opening the
door of the vacuum inlet valve to insert
the cleaning hose, care should be taken
not to distort the door by forcing it too far
open. Do not turn the system
www.centralvacuumstores.com 4
THANK YOU FOR CHOOSING AN IMPERIUM PRODUCT.