Full Product Manual

5 www.centralvacuumstores.com
Installation Tips
Mounting Bracket
All Imperium central vacuum units have the same mounting bracket. It is attached to the
unit for shipping and then must be removed for installation to the wall.
Still need help? Call 1-800-221-8227.
1 Remove the small
piece of metal on the
side of the mounting
bracket and discard.
2 To remove the
mounting bracket, tap
lightly with a mallet.
The mounting bracket
will slide down.
3 Continue
to tap with a mallet
until the mounting
bracket is completely
removed.
4 Attach the removed
bracket to the wall
and slide the unit onto
the bracket.
Low Voltage Wire Connections
Strip the wire, press the Quick Clips to the
right and insert the wire
into the holes.
Utility Valve Installation
Airflow Direction
ConnectTYfitting
totubingsystem
Forinformationonconnectingvalves&fittings,
refertoinstallationmanual.
Low Voltage Terminals
(Connecttolow
voltagesystem)
Airflow Direction
ConnectTYfitting
totubingsystem
Forinformationonconnectingvalves&fittings,
refertoinstallationmanual.
Low Voltage Terminals
(Connecttolow
voltagesystem)
Airflow Direction
ConnectTYfitting
totubingsystem
Forinformationonconnectingvalves&fittings,
refertoinstallationmanual.
Low Voltage Terminals
(Connecttolow
voltagesystem)
Airflow Direction
ConnectTYfitting
totubingsystem
Forinformationonconnectingvalves&fittings,
refertoinstallationmanual.
Low Voltage Terminals
(Connecttolow
voltagesystem)
Airflow Direction
ConnectTYfitting
totubingsystem
Forinformationonconnectingvalves&fittings,
refertoinstallationmanual.
Low Voltage Terminals
(Connecttolow
voltagesystem)
Airflow Direction
ConnectTYfitting
totubingsystem
Forinformationonconnectingvalves&fittings,
refertoinstallationmanual.
Low Voltage Terminals
(Connecttolow
voltagesystem)
Make sure the Protector Plate is in place. This is necessary
for proper suction.
Upon receiving your vacuum system, lift o the lid. The
protector plate should be located inside the can just below
the bag.
The protector plate is installed correctly when it lays at,
prong side down, directly under the bag. The warning
label should be facing up. The plate provides a
barrier between the bag and mesh screen. This
allows air to circulate preventing the motor from
overheating.
Do not to throw this part away.
Protector Plate
Protector plate must be installed
properly for the vacuum to work
Proper placement of protector plate (for paper bag models only)