Use and Care Manual

6
HOW TO ADD WATER
Step 1: Open the door as shown in diagram
Step 2: Remove the tank by pulling it upward, take care not to spill water
Step 3: Turn the water tank so that the bottom side is facing upwards
Step 4: Remove the tank cover as shown and add distilled water to the tank. If
desired, add ice cubes to the tank, screw on the tank cover, then flip the
tank and return it to the fan body, ensuring that it is balanced.
REMOTE CONTROL INSTRUCTIONS
Plug in the fan, and check that the indicator is on. Point the remote control at the
receiving screen on the panel and press the function keys to select which function
you would like to run.
ON/SPEED Press once to start the fan then push again to adjust speed. It will show
speeds 1, 2, and 3.
SWING Press once, “swing” signal will turn on and the fan will oscillate 180°.
TIMING Push to set the time that you need up to 8 hours in 1 hour increments. The
LED display will reflect your selection.
WIND Three settings:
Normal: The default setting, will operate the 1, 2, or 3 speed.
Natural: Simulates real wind with varying power levels.
Sleeping: The fan will adjust from middle natural and weak natural in
half hour increments until the preset time is completed.
ANION Powers on the negative ion generator. When the indicator light is on it
will release negative ions to purify the air.
SPRAYING This activates the humidifier, the indicator light will activate and mist will
be released. This can work with the fan to cool the air or be used alone.
MOSQUITO
REPELLENT
Turns on/off the mosquito repellent function, can be used alone or with
other functions. Call 877-GO-SUNHEAT for replacement mosquito mats.
OFF This will shut off all functions, the anion function can be used while all
other functions are off.
The remote control should be pointed toward the receiver if using. If it is
not working check the battery power and/or replace the batteries.
7
SETTINGS AND ADJUSTMENTS
Humidifying
Function
Uses ultrasonic high frequency oscillation principles to atomize the
water into 1-5 micron ultrafine particles through the pneumatic set-
ting, then diffuses the water into the air, making the air more humid.
Mosquito
Repellent
Function
Utilizes and distributes incense to achieve a repellent effect when the
metal plate is heated evenly.
Ice gel pack
Function
Cools the water using inserted ice cubes.
Anion
Function
Uses an anion generator which uses a pulse and a high oscillation
circuit in order to produce corona and oxygen molecules. These will
effectively produce reactive oxygen species and sterilize the air.
Temperature
Display
Function
Electronic thermal sensors detect indoor temperatures, will work in
unison with the fan, and there is no switch for this function.
Waterless
Alarm
Utilizes a sensor in order to control the water level, if the water level
is too low the alarm will sound three times, “DRY” signal on the
display will flash, and the spraying function will not work due to
automatically disconnected power.
HEALTHY HUMIDITY
A dry environment can lead to a loss of excessive body water and accelerates aging.
Moist air can keep vitality. Keep a comfortable level of 45%RH-65%RH under vari-
ous conditions in order to look and feel better. The ultrasonic mist fan will help to
achieve this goal and create a comfortable environment.