Installation Guide

1.
Remove the handshower from the hose by unscrewing the hose
conical counter-clockwise (Fig 1).
3. Remove any debris from the flow controller/check valve. Reinstall
the flow controller/check valve by pressing into opening of the
handshower handle. Then reattach the hose conical to the handshower
threads.
2.
The flow controller/check valve is located at the opening of the
handshower handle and has a different color plastic housing than
the handshower conical threads (Fig 2). Use the needle-nose pliers
to grasp the flow controller/check valve and pull the flow
controller/check valve out. Take care not to use excessive force
when grasping perimeter edge of the flow controller/check valve
so as to avoid damage (Fig 2 & 3).
Fig 4
Fig 5