Installation Guide

NICOR, Inc. | rev 12.10.14
DLS Surface Mount LED Downlight
INSTALLATION INSTRUCTIONS
Model(s):
DLS4-20XX-120-#K-&&
4” Housing Installation
existing trim, lamp and mounting bracket (if any) and remove the socket
from the plate.
Screw the Edison base into the socket and carefully route the wires into the
ceiling.
1
2
3
4
3
4
Standard 4” J-Box Installation
splice to the building ground wire.
Mount the bracket to the existing J-Box with 2 mounting screws (included)
live (black) and neutral (white) wires are accessible from the J-Box and splice
(black) and white to neutral (white).
clips into the bracket.
1
1
2
2
3
4
4
WARNING:
•Risk of electric shock. Disconnect power at fuse or circuit breaker before installing or servicing.
•To prevent early lamp failure, lamp should only be installed in operating environments between -20°C et + 40°C (104°F et -4°F)
•No user serviceable parts inside. To avoid electric shock do not disassemble product.
ATTENTION:
Suitable for use in wet locations. Use only on 120VAC, 60Hz circuits.
NOTE:
Title 24 Installation:
adapter (sold separately) and connect to the GU socket in the housing.

Summary of content (2 pages)