Installation Guide

ManualsBrandsUnbranded ManualsFireplace Accessories & Parts6 in. Draft Regulator

6” BAROMETRIC DRAFT

REGULATOR

Owner’s Manual

(Save this manual for future reference)

SAFETY INSTRUCTIONS

READ ALL INSTRUCTIONS CAREFULLY

BEFORE STARTING THE INSTALLATION

OR OPERATING THE UNIT. FAILURE TO

FOLLOW INSTRUCTIONS MAY RESULT IN

PROPERTY DAMAGE, BODILY INJURY, OR

EVEN DEATH.

SAFETY NOTICE: IF THIS UNIT IS NOT PROPERLY INSTALLED, A HOUSE/BUILDING FIRE

MAY RESULT. FOR YOUR SAFETY, CONTACT LOCAL BUILDING OR FIRE OFFICIALS ABOUT

PERMITS, RESTRICTIONS, AND INSTALLATION REQUIREMENTS FOR YOUR AREA.

TO BE USED WITH SOLID FUEL BURNING

APPLIANCES ONLY. (NO EXCEPTIONS)

DO NOT USE THIS UNIT IN A MANUFACTURED

HOME, MOBILE HOME, TENT, OR TRAILOR.

(NO EXCEPTIONS)

For customer service: call (800)750-2723 or write 227 Industrial Park Rd. P.O. Box 151 South Pittsburg, TN 37380

Part No.: 852114

Summary of content (4 pages)

PAGE 1
6” BAROMETRIC DRAFT REGULATOR Owner’s Manual (Save this manual for future reference) SAFETY INSTRUCTIONS TO BE USED WITH SOLID FUEL BURNING APPLIANCES ONLY. (NO EXCEPTIONS) READ ALL INSTRUCTIONS CAREFULLY BEFORE STARTING THE INSTALLATION OR OPERATING THE UNIT. FAILURE TO FOLLOW INSTRUCTIONS MAY RESULT IN PROPERTY DAMAGE, BODILY INJURY, OR EVEN DEATH. DO NOT USE THIS UNIT IN A MANUFACTURED HOME, MOBILE HOME, TENT, OR TRAILOR.
PAGE 2
SAFETY INSTRUCTIONS READ ALL INSTRUCTIONS CAREFULLY. 1. The installation of this unit must comply with your local building code rulings. Please observe the clearances to combustibles as specified in the stove manufacturer’s manual. 2. Do not install this unit in a manufactured home, mobile home, tent or trailer (NO EXCEPTIONS). 3. Always connect this unit to a chimney that is vented to the outside. Never vent to another room or inside a building. 4.
PAGE 3
INSTALLATION INSTRUCTIONS 1. Check the Owner’s Manual for your stove and install according to the stove manufacturer’s instructions. If there are no instructions for draft control devices, follow the instructions below. NOTE: For proper operation, the chimney must be clean and free of any obstructions before installation. 2. Do not reduce any minimum clearances which may be listed in the stove manufacturer’s manual. Check your local and state building codes for proper and safe installation. 3.
PAGE 4
OPERATING INSTRUCTIONS Chimney draft is critical to the proper operation and control of wood or coal burning stoves. Too much draft will cause fuel to be quickly consumed, create excessive heat and potentially cause the stove to over fire. Proper draft for most coal and wood burning stoves will be measured with a draft gauge reading of between 0.04˝ to 0.08˝ w.c. The Barometric Draft Regulator is designed to be easily adjusted and provide proper operating draft levels. 6.