Instructions / Assembly

DD01E

CENTER OF MAGNET

(IN HOLDER)

MUST BE 15/16” FROM THE

SENSOR MOUNTING PLAT

SENSOR

MOUNTING

PLATE

ALIGNMENT

GUIDES

ON BOTTOM

OF DD01E

THE ALIGNMENT GUIDE

IS AT 15/16” FROM

BACK PLATE.

IR CONDITIONING SENSOR

IMPORTANT NOTE: When properly installed, the center line mark on the bottom of the DD01E will line up with the center

of the line of the magnet holder containing the magnet. Choose magnet position A, B, or C to align the magnet 15/16”

from the back of the DD01E.

Door Sensor Operation Verification

NOTE: Do NOT attempt to bind a DD01E unless proper operation has been validated.

To verify that door sensor is installed properly:

1. Install batteries into DD01E and snap sensor onto wall plate.

2. Close the door. Green light in lens should illuminate. Open door and green light will turn off. Repeat this step

several times to ensure door sensor is operating correctly.

Procedure must be accomplished within one minute. If not accomplished within one minute, remove batteries and

repeat Steps 1 & 2.

Configuration Settings

The PTAC control will automatically self-configure to work with the wall thermostat (DS01E Kit) if installed and bound. The

PTAC control will automatically self-configure to activate pre-configured energy management routine when the DD01E is

installed and bound to the PTAC. Additionally, the setback times and setback temperatures can be changed using the

configuration settings. If you are using DP01* Front Desk Platform, the PTAC control will need to be configured to identify

its room number placement.

Standard and DS01E Configuration

To enter configuration feature mode:

Press and continue to hold the up and down arrow keys and quickly press the OFF key twice within

a two (2) second time frame. You will see “ - - “ displayed. Once you are in the configuration program, you can use

the HEAT button to move UP the various configuration settings or the COOL button to move DOWN the configuration

settings. The + or - keys will move up or down the selectable codes that you can change for each configuration

setting. Ensure that you are in the proper configuration setting before pressing the + or - key as you may accidentally

change a setting that you did not intent to change.

The display will alternate between displaying the feature code and the option code 0 (factory default setting).

Press the HEAT button one time to get into C1 mode and then the display will alternate between C1 and 0 - the

factory default. If an RF DS01* has been bound to the unit the display will alternate between C1 and rE. The lower

right dot on the display will flash.