40V Lithium Ion Cordless Line Trimmer MODEL # 106065 (106064 Kit) Operation Manual ! This safety alert symbol identifies important safety messages in this manual. Failure to follow this important safety information may result in serious injury or death. Part # 107368 Rev A Downloaded from www.Manualslib.
For Service or Questions Call 1-877-487-8275 720-287-5182 www.redbackpowerusa.com Redback products are distributed by 1100 W 120th Ave, Suite 600 Westminster, CO 80234 • 720-287-5182 Downloaded from www.Manualslib.
Table of Contents Important Safety Information Intended Use ...........................................................................................4 Personal Protective Equipment ............................................................4 General Safety .........................................................................................5 Safety Decals ..........................................................................................6 Line Trimmer Assembly..................................
Important Safety Information ! WARNING WARNING: Read and thoroughly understand all instructions and safety information before assembling or operating the line trimmer. Failure to do so may cause serious injury or death. Do not allow anyone to operate this line trimmer who has not read this manual. As with all power equipment, a line trimmer can be dangerous if assembled or used improperly. Do not operate this line trimmer if you have doubts or questions concerning safe operation.
Important Safety Information General Safety Failure to follow warnings, cautions, assembly and operation instructions in the Operation Manual may result in serious injury or death. ! DANGER READ THE OPERATION MANUAL BEFORE OPERATION. • Do not permit children to operate this equipment at any time. • Do not permit others that have not read and understood the complete Operation Manual to operate this equipment. • The line trimmer can propel objects it strikes at high speeds.
Important Safety Information Safety Decals Safety labels on the line trimmer are to remind you of important information while you are operating the unit. Make sure all safety warning decals are attached and in readable condition. Replace missing or defaced decals. Contact Redback USA at 1-877-487-8275 for replacement decals. 40V 40V 40V 40V 6 Downloaded from www.Manualslib.
Line Trimmer Assembly 2 4 Places TRIMMER GUARD 1 Figure 1 Installing the Trimmer Guard The trimmer guard is an essential part of the line trimmer and must ALWAYS be used to prevent damage to the trimmer and injury to the operator. The guard is not attached to the trimmer when it is delivered to avoid damage in transit. To attach the guard, loosen and remove the 4 screws from the underside of motor housing (see Figure 1). Place the guard on the motor housing 1 and align the bores vertically.
Line Trimmer Assembly Set the shaft length Adjust the trimmer length to the height of the user (see Figure 7). Loosen the threaded sleeve on the shaft coupling 1. Extend the lower shaft until the ideal handle length is reached 2. Tighten the threaded sleeve 3. Set the handlebar Adjust the handlebar to the height of the user (see Figure 8). Loosen the locking lever on the handlebar 1. Set the handlebar to the required position 2. Secure the handlebar by folding down the locking lever.
Overview of Components BATTERY INSERTION RECEPTACLE HANDLE SWITCH INTERLOCK ON/OFF SWITCH CUTTING HEAD COVER SHOULDER STRAP FASTENING LOOP HANDLEBAR CUTTING HEAD LINE SPOOL LOCKING LEVER CUTTING LINE UPPER SHAFT SPRING CUTTING HEAD SPOOL HOUSING SHAFT COUPLING LOWER SHAFT OPERATING ANGLE LOCK BUTTON MOTOR HOUSING VENTILATION OPENINGS CUTTING HEAD LOCK BUTTON PLANT GUIDE LINE BLADE TRIMMER GUARD SHOULDER STRAP RUNNING WHEEL CUTTING HEAD 9 Downloaded from www.Manualslib.
Operation Clearance cutting The cutting head is guided parallel to the ground. When clearance cutting, guide the lawn trimmer in a semi-circle in front of your body. 3 1 2 Edge cutting The edge cutting function allows you to trim precisely and comfortably along the edge of the lawn. Figure 11 1 Changing the operating mode 1. Press downwards and hold the locking button on the shaft coupling 1 (see Figure 11). Turn the lower shaft by 90° 2.
Operation Automatic line advance You can advance the cutting line without stopping the motor. To advance more cutting line, gently tap the cutting head on the ground while running the lawn trimmer (see Figure 14). The line blade in the guard cuts the line back to the correct length if too much cutting line is advanced. It is best to bounce the cutting head on bare ground or hard earth. Figure 14 Work instructions 1. Attach the shoulder belt to the unit. Pull the shoulder belt over your head.
Maintenance ! 2 CAUTION Before performing any maintenance on the line trimmer, remove the battery. Changing the cutting head (see Figure 15) 1. Press and hold down the lock button 1. 2. Loosen the cutting head by turning in an anti-clockwise direction and remove 2. 3. Attach the new cutting head by turning clockwise. Tighten hand-tight. Replacing the line spool Note: Spare parts must conform with the requirements specified by the manufacturer.
Maintenance Winding the spool with new line Note: Always use a cutting line with a maximum diameter of 1/16” (1.6 mm). If a thicker line is used, the motor may overheat or fail. 1. Remove the line spool as described on page 12. 2. Clean the line spool, remove residues of cutting line. 3. Take approx. 26 feet (8 meters) of new cutting line and fold in half. Figure 19 NOTE: Always use the specified line length! The line may not be released automatically if it is too long. 1.
Cleaning & Storage Cleaning Do not use water or liquid detergents. Remove dirt and dust from the housing with a soft brush and dry cloth. Remove grass clippings from the underside of the trimmer. Keep the ventilation slots clean and free of dust. Storage Remove the battery from the line trimmer when not in use. Store the line trimmer in a dry, dust-free and frost-free place ideally in a temperature range of 50° - 77°F (10-25 °C). Store the battery and the unit separately.
Notes 15 Downloaded from www.Manualslib.
Warranty & Specifications IMPORTANT NOTICE We, the manufacturer, reserve the right to change the product and/ or specifications in this manual without notification. The manual is for information usage only and the pictures and drawings depicted herein are for reference only. Warranty Repair and Service Do not return this product to the store for warranty issues or repair. Call our customer service department at 720-287-5182, 1-877-487-8275, or visit www.redbackpowerusa.