Use and Care Manual
CLEANING THE MICRO EXHAUST FILTER HO
LDE
R
1. The Micro Exhaust Filter Holder slides up and out
of its
housing on the side
of
the
unit.
2. Gently pull the Filter out
of
the Filter Holder. (See Figure
4)
3. Tap Filter gently against trash container
to
free and eliminate excess
dirt
and debris. (See Figure
5)
4. To clean the Filter, wash
in
mild soap and water; rinse and dry thoroughly before using the
unit.
5.
If
a new Filter
is
needed, replace with standard HEPA HF4 filter cartridges. Make sure that
it fits
snugly
in
the
Filter
Holder. Replacement Filters are available through the Customer Service
Department.
6. Slide the Holder back into the unit with the Filter facing
outwards.
IMPORTANT! NEVER OPERATE EYE-VAC HOME WITHOUT THE MICRO EXHAUST FILTER AND FILTER
HOLDER
PROPERLY IN
PLACE.
CLEANING THE COLLECTION
B
IN
The Collection Bin should be washed
periodically.
1. Wash the Bin
in
warm water using a mild soap. Avoid harsh
or
abrasive cleaners
or
sponges. Rinse
thoroughly.
TO AVOID DAMAGE, DO NOT PLACE COLLECTION BIN IN THE
DIS
H
W
A
SHER.
2. Let
it
air dry. Make sure the Collection Bin
is
completely dry before putting
it
back into the EYE-VAC
PROFES-
SIONAL.
3. Insert the assembled Collection Bin following the instructions outlined
in
the USER MAINTENANCE
INSTRUCTIONS on page
3.
IMPORTANT NOTES
Other than cleaning the Dirt Filter and replacing the Micro Exhaust Filter Holder, as described
in
this s
Manual,
this
Automatic Vacuuming
Dust Bin is not user
serviceable. There
are no user
serviceable parts inside
the unit.
Servicing by our Authorized Service Center
is
required
to
avoid damage
to
internal
components.
ST
ORAG
E
1. Unplug unit and clean Collection Bin and all Filters before
storing.
2. Store EYE-VAC HOME indoors,
in
a clean, dry
place.
3. Never store EYE-VAC HOME while
it is still
plugged in. Never wrap cord tightly around the appliance,
use
the
Cord
Storage area on the back
of
the EYE-VAC HOME unit. Do not put any stress on the cord where
it
enters the unit, as
it
could cause the cord
to
wear and
break.
WARNING! TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT USE OUTDOORS OR ON WET
SURF
A
CES.
TROUBLE SHOOTING
Problem
Possible
cause
Possible
Solution
EYE-VAC
HOME
won't
run
1.Not firmly plugged
in
2.Unit
is
in
OFF
position 3.Dirt filter
is not
in
position 4.No power
in wall
plug 5.Blown house fuse
or
tripped circuit
breaker
1.Plug
in
firmly 2.Depress Power Button
to
MAN
or
AUTO
position 3.Re-attach collection bin
lid to
top
of
collection
bin
4.Check house fuse
or
circuit breaker
5.Have a
qualified licensed electrician replace house fuse
or reset circuit breaker
Does not pick up
debris
1.Dirt inlet
is
blocked 2.Container
is full
3.Debris may be too
large
for inlet
First. Depress Power Button
to
OFF position 1.Clean
path
of dirt
inlet 2.Empty collection bin 3.Clear large
debris
EYE-VAC sensors do not
activat
e
1.Unit
is
not
in
AUTO
mode
1.Depress Power Button
to
AUTO
position
Suction
is
not
strong
1.Filters may be
dirty
1. Depress Power Button
to
the OFF
position
2.
Clean
Dirt
filter or
Micro Exhaust filters when
needed.
Status indicator light
blinking
1.Eye-Vac sensors have been
shut
off for
30 seconds which
caused
power
to
the motor
to
be shut
off
1. Depress Power Button
to
the OFF position
2.Check
dirt filter
and micro exhaust filters
to
ensure they are clean
.
Collection Bin Indicator Light
is
ON
1.Collection bin
is full
1.
Empty the Collection Bin; 2.Clean all
dirt filters
Debris at inlet before unit
is
powered
on
1.Depress Power Button
to
the MANUAL
position
2.
Activate unit
manually
English
This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible
harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of
material resources. To return your used device, please use the return and collection systems or contact the retailer where the product
was purchased. They can take this product for environmental safe recycling.
Correct Disposal of this product