Accessories

6
Run an All Stations Cycle (ASC)
Running an All Stations Cycle is useful for troubleshooting a
sprinkler system.
1. Follow Step 1 above.
2. Press to move above P- C
to “TEST ALL”.
3. Press to start the run time
blinking.
4. Press or to set the run time.
All stations will run the same length of time, in sequence,
from lowest to highest possible.
5. Press Enter to start. (Leave the transmitter on
during the ASC sequence.)
Turn On a Station or Zone Manually
1. Turn on the remote and press or to scroll to the
station number desired.
2. Press once to move to run time.
3. Press or to set the station’s one-time manual
running time.
4. Press Enter to start the station. A ashing rain-drop
indicates a running station.
e controller may display a diering countdown. If so, it
has been overridden by the remote’s countdown.
Stop All
Press Cancel. A slashed-out raindrop indicates an
interrupted irrigation program.
Change from One Running Station to Another
1. Press or to select the desired station.
2. Press once to move to run time.
3. Press or to set the run time.
4. Press Enter to start the station. e previously
running station will shut o .
Remote Auxiliary Operation
e controller is capable of controlling an auxiliary system
(such as a lighting system) using AUX devices. e EVO-HH
handheld remote can control the auxiliary system too.
Switch to Auxiliary Operation
1. Hold down the
Mode
PWR(Hold)
button for a few seconds until
“A U” appears in the screen.
2. Release the button. e remote is
in Auxiliary mode.
3. Set the PIN on the remote
(see page 5) to communicate
with the auxiliary controller.
Enter
Setup PWR (Hold)
Mode
Cancel
TEST
ALL
03
RUN MIN
TIME
Enter
Setup PWR (Hold)
Mode
Cancel
A U