Manual

Technical Support: 1-877-345-8676 (US & Canada)
[e-mail] (international)
©2014 e Toro Company, Irrigation Division • www.toro.com
Form Number 373-0812 Rev. B
Specifications
• Dimensions:
6.5” (16,5 cm) wide x 6” (15,2 cm) high (over 3.75” [9,5 cm]
antenna) x .75” (1,9 cm) deep
• receives power from controller
• RF reception range:
500’-1000’ (152-305 m) LOS (line of sight)
depending on equipment used
• Operating temperature range:
14° – 140° F ( -10°– 60°C)
FCC Part 15 Rules
is equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. ese limits are designed
to provide reasonable protection against harmful interference in a residential in-
stallation. is equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment
generates interference to radio or television reception, which can be determined
by turning the equipment on and o, the user is encouraged to try to correct the
interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit dierent from that to
which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.
e user may nd the following booklet prepared by the Federal Communica-
tions Commission helpful: “How To Identify and Resolve Radio-TV Interfer-
ence Problems”. is booklet is available from the U.S. Government Printing
Oce, Washington, DC 20402. Stock No. 004-000-00345-4.
Technical Information
LISTED
FCC-ID: OF7ESC
IC: 3575A-ESC
Australian Warranty Statement
is product comes with a manufacturer’s guarantee against defects in
material and workmanship when used for its intended purpose. Our
obligation under this guarantee is limited to the repair or replacement of the
product at our discretion for the period stated. In the event of a claim, you
must immediately cease using the product and return the product, together
with your proof of purchase and an explanation of the fault to the store you
purchased it from. All costs associated with the return of the product are the
purchasers’ responsibility. To process the warranty, the retailer must contact
Toro Australia via their representative or the phone number listed below.
Our goods come with guarantees that cannot be excluded under the
Australian Consumer Law. You are entitled to a replacement or refund for a
major failure and for compensation for any other reasonably foreseeable loss
or damage. You are also entitled to have the goods repaired or replaced if the
goods fail to be of acceptable quality and the failure does not amount to a
major failure.
Toro Australia Pty Ltd, 53 Howards Road, Beverley SA 5009 1300 130 898,
[e-mail]